Fixing Insert Right Angled

RFA-Tech Fixing Inserts with Right Angle provide a cost effective threaded fixing system in cast concrete with a strength of 30N/mm² and above, where either the unit or speed of installation required does not permit the use of a high yield reinforcement tail bar. They are effective for a single point fixing where no tolerance is required for attchment. They are manufactured from either high grade zinc plated mild or stainless steel tube.

Fixing Inserts with Right Angle can be used in conjunction with Plastic Nailing Plates or Magnetic Holding Plates to provide a recess that can be made good on site. Plastic Stopper Caps are also available to protect threads from weathering and ingress of dirt or foreign matter that can prevent the threads from engaging completely down the length of the socket.

All products are rigorously tested, inspected and supplied with test data on request.

Basic Use Instructions

All Fixing Inserts with Right Angle should be fitted inside a re-bar cage befitting the unit as specified by the design engineer, and should observe the edge distances as detailed in our Technical Manual (Page 55).

The safe working loads are based upon a three and a half times the axial load capacity, provided a minimum concrete strength of 30N/mm² has been achieved.